Engine oil additive for petrol engines - Wolfram NANO coating 140ml

Tests from Brno University of Technology confirm excellent efficiency - reduction of wear by almost 9 times. Thanks to this, everywhere (engine and gearbox) where you use IF-WS2 additives, you will substantially extend the service life without service costs. You will also reduce the cost of fuel or oil consumption and increase the performance of your car.

IF-WS2 nanoparticles are among the most lubricating materials known. As a result, the additives reduce the coefficient of friction (reduce passive drag) and thus reduce fuel consumption. In addition, the surfaces of the engines are smoothed (rough spots are sealed) and this also saves PHM and especially oil in engines that have higher consumption.

Due to the reduction of passive resistances, the efficiency (power increase) of the engine functionality is increased. In engines, there is an increase in performance due to the self-repairing properties (surface smoothing) of IF-WS2 particles. In cars with high mileage, customers say that after application of IF-WS2 additive, the engine "restarts" and the car runs like new.

Due to the reduced friction, engine effort and harmful emissions are also reduced. In older cars or cars with high mileage, the surfaces will be treated significantly, reducing fuel and oil consumption and harmful emissions.

Store in a warm place before use, or warm in warm water, shake and pour into a warm (not a requirement) engine. After application, you can drive immediately, or at least start for a few minutes. IF-WS2 additives are always applied after an oil change. As the old oil is drained, the particles are washed out. The additives can be applied to both new and old oil. Particles always work. Additives can be used in old (vintage) and new, modern and sports cars. The additives are suitable for engines with a DPF.